Korg NAUTILUS Series, Parameter Manual, Page: 429 / 961

COMBINATION > MIDI Filter/Zones 3–6: Velocity Zones
419
3–6: Velocity Zones
Sets the Top/Bottom Velocity parameters to specify the
range of velocities that will sound for each timbre 1–16, and
set the Top/Bottom Slope parameters to specify the range
over which the volume will change.
Velocity Switch: By setting two or more timbres to velocity
zones that do not overlap, you can use variations in playing
dynamics to play different sounds.
Layer: If you set two or more timbres to velocity zones that
overlap, the sounds will be heard together.
Velocity Cross-fade: If the slope ranges (gray line) overlap,
different sounds will be sounded together, and your playing
dynamics will determine the proportion of each sound.
It is not possible to set the bottom velocity greater than
the top velocity for the same timbre. Nor can the top
slope and the bottom slope overlap.
3–6a: Zone Map
This area provides a graphic display of the note and velocity
ranges in which each MIDI Track will sound. The slope
portions of the zones are displayed in a different color.
Under the Key Zone graphic, a keyboard graphic shows the
most recently-played note in green, aligned with the
keyboard zones.
To the left of the Velocity Zone graphic, a meter shows the
velocity of the most recently-played note; red dots above the
graphic show the Zone(s) triggered by that velocity.
For more information, please see “3–5a: Zone Map” on
page 417.
3–6b: Velocity Zones
Timbre 01
Top Velocity [1…127]
Specifies the maximum velocity value that will sound each
timbre.
Top Slope [0…120]
Specifies the number of velocity steps over which the
original volume will be reached, starting from the Top
Velocity.
0: The volume will be at the original value from the top
velocity.
120: The volume will decrease as the velocity approaches
the top velocity.
Bottom Slope [0…120]
Specifies the number of velocity steps over which the
original volume will be reached, starting from the Bottom
Velocity.
0: The volume will be at the original value from the bottom
velocity.
120: The volume will decrease as the velocity approaches
the bottom velocity.
Bottom Velocity [1…127]
Specifies the minimum velocity value that will sound each
timbre.
3–6PMC
3–6a
3–6a
1–1a
1–1b