Korg NAUTILUS Series, Parameter Manual, Page: 418 / 961

COMBINATION mode
408
2–3: Pitch
Here you can make pitch-related settings for each timbre.
2–3a: Pitch
Timbre 01
Transpose [–60…+00…+60]
Adjusts the pitch of each timbre in semitone steps.
12 units equal one octave.
When Status (0–1b, 2–1a) is INT, this parameter will
affect the pitches sounded by the NAUTILUS. When
Status is EXT, this parameter will affect the note
numbers of the MIDI note messages that are transmitted.
For example if you make settings of +04 and +07
respectively for two timbres that are set to EXT, playing
the C key will transmit a C note number on the global
MIDI channel, and at the same time will also transmit E
and G note numbers on the MIDI channels of those
timbres.
Detune (Use BPM Adj. in Page Menu)
[–1200…+0000…+1200]
Adjusts the pitch of each timbre in one-cent units.
+0000: Normal pitch.
Note: You can also use the Detune BPM Adjust menu
command to alter a loop’s tempo via detuning. Since this
will alter the pitch of the loop along with the tempo, it’s
generally suited only to un-pitched percussive loops. For
more information, see “Detune BPM Adjust” on page 437.
Transpose and Detune can be controlled via MIDI RPN
messages. The way that this works depends on whether or
not the Timbre uses an HD-1 Drum Program.
If the Timbre does not use an HD-1 Drum Program–for
example, if it uses a Single or Double HD-1 Program, or
an EXi Program–then MIDI RPN Coarse Tune will
control
Transpose , and RPN Fine Tune will control
Detune .
If the Timbre uses an HD-1 Drum Program, MIDI RPN
Coarse Tune and Fine Tune will be combined to control
Detune . The overall range is ±1 octave for coarse tune
and fine tune together.
Bend Range [PRG, –24…+00…+24]
Specifies the amount of pitch change that will occur when
the pitch bender is operated, in semitones.
PRG: The pitch range specified by the program will be used.
–24…+24: This setting will be used regardless of the setting
in the program.
The MIDI RPN Pitch Bend Change message can be
received to control this and change the setting. (However
it will not be received if this parameter is set to PRG.)
This message is received on the MIDI channel for each
timbre set by
MIDI Channel (2–1a).
Use Program’s Scale [Off, On]
Timbre can use the scale that is specified by Scale
(PROGRAM 1–1c).
On (checked): The scale specified by the program will be
used.
Off (unchecked): The scale specified by Scale (2–3b) will
be used.
Timbres 02…16
These are the pitch-related settings for timbres 2 through 16.
The settings are the same as for timbre 1. For more
information, see “Timbre 01”.
2–3PMC
2–3a
2–3b
1–1a
1–1b