Pitch
61
Constant Time
: Portamento will always take the same amount of time to glide from one note to another, regardless of
the difference in pitch. This is especially useful when playing chords, since it ensures that each note in the chord will
end its glide at the same time.
Time
[0.0000…50.0000 secs or secs/octave]
This controls the portamento time. If
Type
is set to
Constant Rate
, the units are secs/octave (seconds per octave). If
Type
is set to
Constant Time
, the units are simply secs (seconds).
Pitch Mod
These settings apply to the entire Program, including Osc 1/2 and the Sub Oscillator. To modulate the pitches of
individual Oscillators, use the Osc Pitch page instead.
LFO
(INTENSITY)
[–144.00…+144.00]
This controls the initial effect of the Pitch LFO on the pitch, in semitones.
Pitch Bend Up
[–60…+60]
This sets the maximum amount of pitch bend, in semitones, when you move the wheel above the center point. For
normal pitch bend, set this to a positive value.
Pitch Bend Down
[–60…+60]
This sets the maximum amount of pitch bend, in semitones, when you move wheel below the center point. For normal
pitch bend, set this to a negative value.
