Korg M50-73, Parameter Manual

Page: 84 / 419

Program mode
76
Copy Insert Effect
Copy Insert Effect is available on all of the IFX pages.
This command copies effects settings from within the
current Program, from other Programs, Combinations, or
Songs.
To execute the Copy Insert Effect command, press the OK
button. To cancel, press the Cancel button.
If you’re copying from a master effect, the result will
not be identical due to differences in the routing and
level settings of the master effects.
From (Mode) [Program, Combination, Song]
This selects whether you’ll copy from a Program, a
Combination, a Song, or the current Sampling Mode
settings.
From (Bank and Number) [Bank and Number]
For Programs and Combinations, this selects the Bank and
Number from which to copy. When this parameter is
selected, you can also use the front-panel BANK buttons to
select Banks.
(Effects slot select) [IFX 1…5, MFX 1&2, TFX]
Select which of the effects you wish to copy.
You can also copy from a master effect and total effect.
All [check-box]
When this is enabled, the settings of all insert effects (the
contents of the Insert FX page and the effect parameters of
IFX1–5, but not
Ctrl Ch ) will be copied.
To [IFX 1…5]
This selects the insert effect copy destination.
Post IFX Mixer Settings [check-box]
When this is checked, the Pan , Bus (Bus Select) , Ctrl (FX
Control Bus) , and Sends 1 and 2 settings that follow the
copy source insert effect will also be copied.
When this is not checked, only the effect type and its
parameters will be copied.
Copying 000: No Effect
Copying a single effect set to “000: No Effect” will not work:
no data will be copied.
If either All or All used is selected, and “000: No Effect”
exists within a chain, it will be copied. However, if the entire
chain consists of “000: No Effect,” nothing will be copied.
Swap Insert Effect
Swap Insert Effect is available on all of the IFX pages.
This command exchanges the effects, and their internal
parameters, between two IFX slots.
All of the parameters shown on the IFX 1–5 pages will be
copied.
Other IFX slot parameters will not be affected, including
Pan, Sends 1 and 2, Chain, AUX Bus, and FX Control Bus.
1. In Source 1 and Source 2, select each of the insert
effects that you wish to swap.
Copy MFX/TFX
Copy MFX/TFX is available on all of the MFX/TFX pages.
This command lets you copy any desired effect settings from
Program, Combination, or Song.
1. Use the From field to select the copy source mode,
bank, and number.
You can also use the BANK SELECT switches to select the
desired bank.
2. Select the effect that you want to copy.
You can copy from an insert effect by selecting IFX1–5.
If you copy from an insert effect, the result may not be
exactly the same, due to differences in routing and level
settings.
If you select MFX1 or MFX2, the Return level will be copied
at the same time.
You can copy settings from a total effect by selecting TFX.
If you check All MFXs , all master effect settings will be
copied.
If you check TFX , all total effect settings will be copied.
Master Volume settings will not be copied.
3. In To, specify the copy destination master effects or
total effect.