Program mode
74
Copy Tone Adjust
Tone Adjust tab of the play page.
This command replaces the current Tone Adjust settings
with those of any other Program, Combination Timbre, or
Song Track.
1. Use the From field to select the copy-source mode,
bank, and number.
You can use the front-panel BANK switches to select the
desired bank.
2. In the Timbre field (if you’ve selected a Combination)
or Track field (if you’ve selected a Song), select the Tim-
bre or Track to copy from.
3. Select either All or Assignments Only to specify the
Tone Adjust parameters you want to copy.
All:
This copies both the Tone Adjust parameter
assignments and values.
Assignments Only:
This copies only the Tone Adjust
parameter assignments, without the values.
Reset Tone Adjust
Tone Adjust tab of the play page.
This command resets the Tone Adjust settings for all of the
displayed Switches and Sliders to their default values.
1. Use the To field to specify how the Switches 1–8, Slid-
ers 1–8, and Master Slider parameters will be reset.
All Off:
All will be reset to Off.
Default Setting:
The parameters will be reset to the default
values.
Copy Oscillator
Copy Oscillator
is available on all of the tabs under the
Basic/Ctrls Controllers– Chord Trigger, OSC/Pitch, Filter,
Amp/EQ, AMS/C.KTrk pages.
This command is used to copy the settings from one
oscillator to another.
1. Use the From field to select the oscillator that you want
to copy.
2. Use Program to select the bank and number of the
copy-source program.
You can press a BANK SELECT switch to select the desired
bank.
3. In To, specify the copy destination oscillator.
Swap Oscillator
Swap Oscillator
is available on all of the tabs under the
Basic/Ctrls Controllers– Chord Trigger, OSC/Pitch, Filter,
Amp/EQ, AMS/C.KTrk pages.
This command exchanges the settings of oscillators 1 and 2.
Note:
This can be selected only if
Oscillator Mode
(Prog 1–
1a) is Double.
Copy Drum Track
Copy Drum Track
is available on the DrumTrk Pattern tab
or DrumTrk Program tab of the ARP/DT.
This command copies settings from the specified program,
combination/timbre, or song.
1. Use the From field to select the mode, bank, and num-
ber of the desired copy-source. You can press a BANK
switch to select the desired bank.
2. If you execute this command in Program mode, and
select Program in From, the additional field Program
Settings too will appear.
On (checked):
The parameter settings of the Drum Track
Pattern page and Drum Track Program page will be copied.
Off (unchecked):
The parameter settings of the Drum Track
Pattern page will be copied.
If you execute this command in Combination or Sequencer
mode, the parameter settings of the Drum Track Program
page will be copied. However, the
MIDI Channel
setting
will not be copied.
Summary of Contents for M50-73
