Korg HT-70, Owner'S Manual, Page: 12 / 76

12
Playing along with the metronome
It’s convenient to use the metronome when you want to play to an accurate tempo.
To sound the metronome
1. Press the [ ] switch.
The [ ] switch will light.
2. To stop the metronome, press the [ ] switch once again.
The [ ] switch will go dark.
Changing the Metronome Settings
Settings described here (with the exception of tempo and time signature) are retained even
while the power is off. When you press [
] after making each change, the HT-70 automatically
writes the new value into nonvolatile memory. During this time, the multidisplay will indicate
that writing is in progress (
☞
p.5
).
Do not turn the HT-70 power off while writing is in progress. Doing so may cause loss or cor-
ruption of memorized settings and song data.
Changing the Tempo Setting
1. Hold down [ ] for at least one second.
The switch begins flashing.
2. The TEMPO indicator LED (next to the [DISPLAY] switch) comes on, and the multidis-
play shows the current tempo setting.
If the TEMPO indicator LED does not come on, press [TEMPO (
■
)].
3. Use [
▲
] or [
▼
] to set the desired tempo.
Press briefly to change the value by 1, or hold the switch down to change continuously.
If you wish to reset the tempo to its factory default, press [
▲
] and [
▼
] at the same time.
The available range is ( =) 4 to 250.
4. When you have made set the value, press [ ] again.
The HT-70 returns to its previous state. The [ ] switch stops flashing (either goes off
or else comes on solid).
1, 2
1, 4
2
3
3