Korg Ci-8600, Owner'S Manual, Page: 53 / 112

53
Automatic
accompaniment
“Custom Style 2/2” page
You can make the settings listed below for each accompaniment part: Drum, Perc,
Bass, Acc1, Acc2, Acc3, Upp1, Upp2, and Low.
“Part” cell
To change the part, use the cells “ ▲ ”, “ ▼ ” or the dial, [VALUE] switches.
“Wrap Around” cell
This setting can be made for the Bass, Acc1, Acc2, and Acc3 parts. You can specify
the chord root at which the octave will be changed when the accompaniment of
these parts becomes excessively high or low. With a setting of “Org,” the original
setting of the style will be used.
For example if this is set to a value of “1,” the accompaniment will drop by one
octave when a chord of C# is specified. If this is set to a value of “2,” the accompani-
ment will drop by one octave when a chord of D is specified.
With setting “1”
C chord
→
1 shown
C# chord
→
1 by a semitone and lower by an octave 2
D chord
→
1 by a semitone and lower by an octave 3
With setting “2”
C chord
→
1
C# chord
→
Raise 1 by a semitone 4
D chord
→
3
“Status” cell
This setting can be made for the Drum, Perc, Bass, Acc1, Acc2, and Acc3 parts. You
can whether the automatic accompaniment of each part will be played by the Ci-
9600/Ci-8600 itself, on an external tone device.
“Octave” cell
This setting can be made for the Bass, Acc1, Acc2, and Acc3 parts. You can adjust the
pitch of each part in steps of an octave. This can be adjusted in a range of ±2 octaves.
By setting this in conjunction with “WrapAround,” you can prevent the accompani-
ment from sounding unnatural.
Off: There will be no output, either to the internal tone generator or to MIDI
OUT or PC I/F.
Int: The part will sound only the internal tone generator. It will not be output to
MIDI OUT or the PC I/F.
Ext: The part data will be transmitted from MIDI OUT or PC I/F. It will not be
played by the Ci-9600/Ci-8600 itself.
Both: The part will be output both to the internal tone generator and to MIDI OUT
or PC I/F.
1 2
3
4