18
Mount the AP on a Pole
1.
Turn the JetWave 2450v2 over. Put the pole mounting ring through the middle hole of it. Note
that you should unlock the pole mounting ring with a screw driver before putting it through the
device as the following right picture shows.
2.
Mount the JetWave 2450v2 steadily to the pole by locking the pole mounting ring tightly.
Power Up
1.
Connect power cord to the PoE injector as the following right picture shows.
2. Connect the Ethernet cable that connects the Access Point to the “POE” port of the PoE injector
as figured below.
3. Connect the power plug to a power socket. The Access Point will be powered up immediately.
