IP67 / IP68 Industrial Ethernet Switch
14
www.korenix.com
3.
Feature Configurations
3.1.
Introduction to Command Line Interface (CLI)
The Command Line Interface (CLI) is the user interface of the switch’s embedded
software system. You can view the system information, see the status, configure
the switch and receive a response back from the system by keying in a
command.
There are different command modes. Each command mode has its own access
ability, its own available command lines, and its own different command lines to
enter and exit. These modes are User EXEC, Privileged EXEC, Global
Configuration, and (Port/VLAN) Interface Configuration modes.
User EXEC mode: As long as you login to the switch through CLI, you will be in the
User EXEC mode. You can ping, telnet remote device, and show some basic
information.
Types enable to enter the next mode, and exit to logout. Below is a full command
list.
Privileged EXEC mode: Type enable in the User EXEC mode to enter the
Privileged EXEC mode. In this mode, the system allows you to view current
configurations, reset to default, reload the switch, show the system’s information,
save a configuration, and enter the global configuration mode.
You can type configure terminal to enter the next mode or exit to leave, to see a
list of available command by types ?. Following diagram shows the commands.
Switch>
enable
Turn on privileged mode command
exit
Exit current mode and down to previous mode
list
Print command list
ping
Send echo messages
quit
Exit current mode and down to previous mode
show
Show running system information
telnet
Open a telnet connection
traceroute
Trace route to destination
