10
3. Mounting Installation
3-1. DIN-Rail Mounting
The DIN-Rail clip is already attached on the rear side of JetNet 3212G-2C2F.
JetNet 3212G-2C2F supports EN 50022 standard DIN Rail, in the following
diagram includes the dimension of EN 55022 DIN Rail for your reference
The DIN rail should behind the
spring when install the JetNet
3212G-2C2F onto the standard
DIN Rail.
Follow the steps below to mount
the JetNet 3212G-2C2F to the
DIN-Rail track
1. Insert the upper end of the
DIN-Rail clip into the back of
the DIN-Rail track from its
upper side
2. Lightly push the bottom of the
DIN-Rail clip into the track.
3. Check if the DIN-Rail clip is
tightly attached to the track.
1. To remove the JetNet 3212G-2C2F from the track, reverse the steps above.
