KOOLATRON REMOTE DIMMER SWITCH
Please read the GLOSSARY at the end of the instructions to familiarize yourself with the terms to be used here.
OPERATING MODES
MANUAL
Using the BUTTON on the receiver only, not using a remote control. The BUTTON on the receiver
can be used to do simple operations such as ON / OFF, dimming, and delayed OFF.
DEFAULT
Using a remote control without advanced programming; the receiver is awakened each time you want
to use it by holding down a key for a few seconds until it responds. Any key on a remote can be used
the same as the BUTTON on the receiver to control ON / OFF, and dimming. Default mode is
enabled at all times except when double digit addressing is used.
LEARNING
Learning mode is used to program the receiver for advanced mode, and to change some settings
ADVANCED
The receiver is programmed to associate specific keys with certain functions. Both single and double
digit addressing allow you to easily select one receiver, in a room with many receivers, and control it
separately. Double digit addressing permits addressing a larger number of receivers. Using double
digit addressing disables default mode and allows much better control over the receiver.
MANUAL MODE
In manual mode, no remote control is needed. The BUTTON on the receiver is used for changing the settings, and
can be used to do simple operations such as ON / OFF, dimming, and delayed OFF.
Press the BUTTON to turn on or turn off the appliance connected to the receiver.
Press and hold the BUTTON to step through ten power levels, release the BUTTON at the desired level.
The steps will reverse direction at each end of the power level scale.
The steps will reverse direction if you release, then press and hold again.
The last power level set is retained in memory.
The delayed off feature is set by double-pressing the BUTTON.
The LED on the receiver will pulse to indicate the current setting.
Each double-press will advance the setting to the next level.
To determine the current delay timer setting, double-press the BUTTON, then press and hold the button
1 long pulse
= disabled / instant off
1 short pulse
= 15 minute delay
1 times base delay
2 short pulses = 30 minute delay
2 times base delay
3 short pulses = 60 minute delay
4 times base delay
4 short pulses = 120 minute delay
8 times base delay
As delivered, the receiver has a base delay of 15 minutes. If desired, the base delay can be changed to 30 minutes, 1
hour or 2 hours.
To change the base delay time, first disconnect the receiver from power.
Then, while holding the BUTTON down, reconnect power, the LED will come on.
The LED will remain on for 3 seconds after the BUTTON is released to indicate it is ready to program.
During these 3 seconds, the BUTTON must be pressed to advance the delay base time to the next setting.
The LED on the receiver will pulse to indicate the current setting.
1 long pulse
= return to factory setting
1 short pulse
= 15 minute base delay
2 short pulses = 30 minute base delay
3 short pulses = 60 minute base delay
4 short pulses = 120 minute base delay
The LED will come on for 3 seconds after the pulses have ceased to indicate it is ready to program again.
During these 3 seconds, the BUTTON must be pressed to advance the delay base time to the next setting.
After the 3 seconds , the LED will go off, and the receiver will return to normal operation.
