SMARC-sAL28 User Guide. Rev. 1.0
// 12
1/
Introduction
This manual describes the Smart Mobility Architecture (SMARC) sAL28 (NXP LS1028) board. The Advanced RISC
Machines (ARM) based module is equipped with a NXP i.MX7 processor. The dual core SoC take advantage of the
optimized power consumption and performance ratio.
The use of this Users Guide implies a basic knowledge of PC hard- and software. This manual is focussed on
describing the special features and is not intended to be a standard PC textbook. New users are recommended to
study the short installation procedure stated in the following chapter before switching on the power.
All configuration and setup of the CPU board is either done automatically or manually by the user via the BIOS setup
menus.
Latest revision of this manual, datasheet, BIOS, drivers and BSP’s (Board Support Packages) can be downloaded
from Kontron Web Page.
Summary of Contents for SMARC-sAL28
Page 1: ...USER GUIDE 1 SMARC sAL28 Doc Rev 1 0 Doc ID 1064 6120...
Page 2: ...SMARC sAL28 Rev 1 0 www kontron com 2 This page has been intentionally left blank...
Page 22: ...SMARC sAL28 User Guide Rev 1 0 www kontron com 22 Figure 4 Bottom View 3 Product label 3...
Page 28: ...SMARC sAL28 User Guide Rev 1 0 www kontron com 28...
