Kontron SBC-815ET-VER, User Manual

Page: 65 / 98

SBC-815ET-VER User’s Guide page 65
Power Management
This category allows you to select the type (or degree) of power saving and is directly
related to "HDD Power Down", "Suspend Mode".
There are three selections for Power Management, three of which have fixed mode
settings.
Min. Power Saving
Minimum power management. Suspend Mode = 1 hr., and HDD
Power Down = 15 min.
Max. Power Saving
Maximum power management. Suspend Mode = 1 min., and
HDD Power Down = 1 min.
User Defined
Allows you to set each mode individually. When not disabled,
Suspend Mode ranges from 1 min. to 1 hr. and HDD Power
Down ranges from 1 min. to 15 min.
Video Off Method
This determines the manner in which the monitor is blanked.
V/H SYNC+Blank
This selection will cause the system to turn off the
vertical and horizontal synchronization ports and write
blanks to the video buffer.
Blank Screen
This option only writes blanks to the video buffer.
DPMS
Initial display power management signaling.
Video Off In Suspend
This allows users to enable/disable video off in suspend mode.
Options: Yes/No
Suspend Type
Two options are available: Stop Grant and Power On Suspend.
Suspend Mode
When enabled and after a set time, of system inactivity, all devices except the CPU will
shut off.
HDD Power Down
When enabled and after the set time of system inactivity, the hard-disk drive will be
powered down while all other devices remain active.