Kontron IP Network Server NSC2U
December 2009
Product Guide, rev. 1.4
95
Optional Component Installations—NSC2U Server
4.9
Installing an Optical Device
The optical device is not hot-swappable. To replace a previously installed device or
install a new one, you must first power down the system and remove the chassis cover
and front bezel as described in
Section 3.2, “General Installation Procedures” on
.
4.9.1
Removing the Optical Device Filler Panel from the Chassis
1. Remove the chassis top cover.
2. Remove the front panel bezel from the chassis to access the optical device slot.
3. Detach the retention clip from the filler panel engagement guide behind the SAS
backplane board. Save it for use on the optical drive.
4. Press on the latch on the back of the engagement guide to release the optical
device filler panel from the backplane. (“A”)
5. Remove the filler panel from the chassis. (“B”)
Figure 81.
Installing the RAID Battery (IBBU)
TS000303
C
B
A
