Kontron mITX-SKL-H, User Manual

Page: 31 / 94

mITX-SKL-H – User Guide, Rev.1.1
www.kontron.com // 31
7/ I/O-Area Connectors
The following connectors are available on the connector panel of the mITX-SKL-H. For information regarding the
connector’s position on the panel, see Chapter 5.2 Connector Panel Side.
7.1. DP Connectors DP1, DP2 (J14)
The mITX-SKL-H display port (DP) connectors are based on standard DP type Foxconn 3VD11203-DPA1-4H or similar.
Figure 6: DP Connectors DP1 (Top) and DP2 (Bottom)
Top
Bottom
Table 4: Pin Assignment DP Connector DP1, DP2 (J14)
Pin Signal Description Type Note
1/21
Lane 0
(+) LVDS
2/22
GND PWR
3/23
Lane 0 (-) LVDS
4/24
Lane 1 (+) LVDS
5/25
GND PWR
6/26
Lane 1 (-) LVDS
7/26
Lane 2 (+) LVDS
8/28
GND PWR
9/29
Lane 2 (-) LVDS
10/30
Lane 3 (+) LVDS
11/31
GND PWR
12/32
Lane 3 (-) LVDS
13/33
Config. 1 Aux or DDC
selection I Internally pull down (1 M
Ω
).
Aux channel on pin-15/17 or pin-35/37 selected as default
(if NC).
DDC channel pin-15/17 or pin-35/37, if HDMI adapter used
(3.3 V).
14/34
Config. 2 (Not used) O Internally connected to GND
15/35
Aux+ Aux Channel (+)
or DDC Clk AUX (+) channel used by DP
DDC Clk used by HDMI
19 13 9 7 5 3 1
16 10 8 6 4 2
39 37 35 33 31 29 27 25 23 21
40 38 36 34 32 30 28 26 24 22