8. Starting Up
KISS 4U KTC5520 – User's Guide (Version 1.01)
8.
Starting Up
The rated voltage of the mains power supply must agree with the voltage value on the type label.
8.1.
Power Cord Connection
The AC input connector is located at the rear side of the KISS 4U KTC5520 system.
Grounding Stud
AC input connector
Fig. 32: KISS 4U KTC5520, rear side without PE marked grounding stud
To connect the KISS 4U KTC5520 platform to an AC power supply, perform the following steps:
1.
The KISS 4U KTC5520 systems with grounding studs marked with a PE symbol have to be grounded by establishing a
large-area contact between the grounding stud (at the rear side) and an appropriate grounding connection point (see
chapter 6.3.3 “Grounding Stud”, Fig. 19 and Fig. 20). Please observe also the labels (“WARNING” and “CAUTION”)
attached to the device.
2.
Connect the AC power cord to the AC input connector.
3.
Connect the other end of the AC power cord to a corresponding mains outlet.
Make sure that the mains power supply (power outlet) is properly grounded and that the power cord is
in perfect condition without any visible damage. An ungrounded power supply is not permissible.
www.kontron.com
31