Kontron EBC2, Manual

Page: 84 / 100

Functional Description EBC2
Page 2 - 46 © 2005 Kontron Modular Computers GmbH ID 29022, Rev. 01
26873
.02.VC.050120/135443
P R E L I M I N A R Y
2.4.29 J33 - CAN2 Connector
This connector is used to provide Controller Area Network (CAN) interfacing. The default con-
figuration for this interface is with opto-isolation. If non-opto-isolation is required, it must be
specified when ordering. This is a standard 9-pin, male, D-Sub connector.
Figure 2-35: J33 - CAN2 Connector
2.4.30 J34 - CAN1 Connector
This connector is used to provide Controller Area Network (CAN) interfacing. The default con-
figuration for this interface is with opto-isolation. If non-opto-isolation is required, it must be
specified when ordering. This is a standard 9-pin, male, D-Sub connector.
Figure 2-36: J34 - CAN1 Connector
Table 2-44: Pinout of J33
PIN SIGNAL DESCRIPTION
1 NC
2 CAN2_L CAN low
3 GND Ground (isolated)
4 NC
5 NC
6 GND Ground (isolated)
7 CAN2_H CAN high
8 NC
9 VCC +5V isolated (max. 90 mA)
Table 2-45: Pinout of J34
PIN SIGNAL DESCRIPTION
1 NC
2 CAN1_L CAN low
3 GND Ground (isolated)
4 NC
5 NC
6 GND Ground (isolated)
7 CAN1_H CAN high
8 NC
9 VCC +5V isolated (max. 90 mA)
6
1
9
5
6
1
9
5