Kontron CP6006-SA, User Manual

Page: 26 / 90

CP6006-SA – User Guide, Rev. 0.5 Preliminary
www.kontron.com // 26
1.5. Standards (preliminary; to be verified)
This product complies with the requirements of the following standards.
Table 2: Standards
Type Aspect Standard
CE Emission EN55022, EN61000-6-3
Immission EN55024, EN61000-6-2
Electrical Safety EN60950-1
Mechanical Mechanical Dimensions IEEE 1101.10
Environmental Climatic Humidity IEC60068-2-78 (see note below)
WEEE Directive 2002/96/EC
Waste electrical and electronic equipment
RoHS 2 Directive 2011/65/EU
Restriction of the use of certain
hazardous substances in electrical and
electronic equipment
Table 3: Additional Standards
Type Aspect Standard Remarks
Environmental Vibration
(Sinusoidal) IEC60068-2-6 Ruggedized version test parameters:
10-300 (Hz) frequency range
2 (g) acceleration
1 (oct/min) sweep rate
10 cycles/axis
3 axes
Single Shock IEC60068-2-27 Ruggedized version test parameters:
30 (g) acceleration
9 (ms) shock duration half sine
3 number of shocks per direction
(total: 18)
6 directions
5 (s) recovery time
Permanent Shock IEC60068-2-29 Ruggedized version test parameters:
15 (g) acceleration
11 (ms) shock duration half sine
500 number of shocks per direction
6 directions
5 (s) recovery time
Customers desiring to perform further environmental testing of the CP6006(X)-SA must
contact Kontron for assistance prior to performing any such testing.
Boards without conformal coating must not be exposed to a change of temperature which
can lead to condensation. Condensation may cause irreversible damage, especially when the
board is powered up again.
Kontron does not accept any responsibility for damage to products resulting from
destructive environmental testing