The uEFI Shell
CP6004-SA/-RA/-RC/CP6004X-SA
Page 64
ID 1053-6161, Rev. 3.0
D R A F T — F O R I N T E R N A L U S E O N L Y
6.2.11
kresetconfig uEFI Shell Command
kresetconfig
FUNCTION:
Control the board reset behavior
SYNTAX:
kresetconfig [-?|<parameter>]
where:
-?
Show help
<parameter>
pcislave [on|off]
Controls if the board shall react on a CPCI backplane
reset if it is used as slave board in a peripheral slot. It
has no effect if the board is located within a CPCI mas-
ter slot.
Note: This parameter is volatile, and at next start is set
to off.
DESCRIPTION:
The
kresetconfig
command controls the board’s reset behavior.
USAGE:
Enable CPCI backplane reset:
COMMAND / RESPONSE EXAMPLE:
Shell> kresetconfig pcislave on
Reset from system master is enabled
Disable CPCI backplane reset:
COMMAND / RESPONSE EXAMPLE:
Shell> kresetconfig pcislave off
Reset from system master is disabled
