CP6003-SA
Functional Description
ID 1044-9757, Rev. 2.0
Page 2 - 13
P R E L I M I N A R Y
2.10.4.2
Analog VGA Connector
On the front panel, the CP6003-SA provides one 15-pin female connector, J9, used to connect
an analog VGA monitor.
* Pin 10 is normally defined as Ground but is used on the CP6003-SA as detection signal of a
connected monitor if the uEFI BIOS setting for the CP6003-SA is “AUTO” (the uEFI BIOS de-
fault setting is “FRONT”).
Note ...
If the automatic VGA detection mechanism on the CP6003-SA is used, the
user must ensure that the VGA cable and the connected monitor have a
Ground signal on pin 10. Otherwise the interface is not operable.
Note ...
The VGA interface can be used both on the front panel and on the rear I/O.
However, the VGA signals are switched to front I/O or rear I/O, depending on
the uEFI BIOS setting.
Figure 2-2: D-Sub VGA Con. J9
15
6
10
11
1
5
Table 2-9:
D-Sub VGA Connector J9 Pinout
PIN
SIGNAL
FUNCTION
I/O
1
Red
Red video signal output
O
2
Green
Green video signal output
O
3
Blue
Blue video signal output
O
10
VGA_DETECT Monitor detection signal
I
13
Hsync
Horizontal sync.
TTL Out
14
Vsync
Vertical sync.
TTL Out
12
Sdata
I
²
C data (EDID)
I/O
15
Sclk
I
²
C clock (EDID)
I/O
9
VCC
Power +5V, 1.5 A fuse
protection
O
5,6,7,8
GND
Ground signal
--
4,11
NC
--
--
