D R A F T — F O R I N
T E R N A L U S E O N L Y
95
www.kontron.com
User Guide
CP3004-SA
4.
Turn the XMC module component-side down, align its XMC connector with the CP3004-HDD’s
XMC connector, J1, and gently press down.
5.
Secure the XMC module to the CP3004-XMC by inserting the four screws (k), (l), (m), and (n)
supplied with the XMC module through the CP3004-XMC’s mounting holes into the XMC mod-
ule’s standoffs and tightening them.
Please refer to Figure 32 for the location of the above-mentioned mounting holes.
6.
Align the board-to-board connectors, J5 and J6, on the CP3004-XMC with the board-to-
board connectors, J8 and J14, on the CP3004-SA and gently press down.
Please refer to Figure 33 for further information on this instruction.
7.
Secure the CP3004-XMC equipped with the XMC module to the CP3004-SA by inserting the
screws (g), (h), (i) and (j) removed in step 3 into the respective mounting holes and tight-
ening them.
Please refer to Figure 34 for further information on this instruction.
8.
Remove the XMC slot cover plate from the XMC bezel cutout of the CP3004-SA front panel, if
mounted.
9.
Attach the front panel to the board assembly and secure it with the screws (a), (b), (c), (d),
(e), and (f) removed in step 2.
If the XMC module is provided with a rubber seal at the bezel, ensure that the rubber seal is
properly seated between the bezel and the front panel cutout when attaching the front pan-
el.
Please refer to Figure 34 for further information on this instruction
The 8 HP CP3004-SA equipped with the CP3004-XMC extension module and an XMC module is now ready
for operation. For the operation of the XMC module, refer to appropriate documentation provided with
the XMC module.
11.4.6 CFast Card Installation
The 8 HP CP3004-SA provides a CFast card socket via the CP3004-HDD or the CP3004-XMC extension
module. For further information regarding the CP3004-HDD module, refer to Chapter 6. For further in-
formation regarding the CP3004-XMC module, refer to Chapter 7.
Note:
The CP3004-HDD does not support removal and reinsertion of the CFast storage card while
the board is in a powered-up state. Connecting the CFast card while the power is on, which
is known as "hot plugging", may damage your system.
To preclude damage or data loss when removing the CFast Card, ensure that the operating
system has been informed of the pending removal and that the OS has indicated that it is
safe to proceed.
