D R A F T — F O R I N
T E R N A L U S E O N L Y
91
www.kontron.com
User Guide
CP3004-SA
11.4.2 Smart Extension Module Installation
A Smart Extension Module may be connected to the 4 HP CP3004-SA via the onboard connector J14.
This optionally available module must be physically installed on the CP3004-SA prior to installation of
the CP3004-SA in a system.
During installation it is necessary to ensure that the Smart Extension Module is properly seated in the
onboard connector J14, i.e. the pins are aligned correctly and not bent.
Note:
The Smart Extension Module module cannot be used in conjunction with the SATA Flash
module, the CP3004-HDD module, and the CP3004-XMC module.
11.4.3 Installation of External SATA Devices
The following information pertains to external SATA devices which may be connected to the CP3004-SA
via normal cabling.
Some symptoms of incorrectly installed SATA devices are:
»
Device on a SATA channel does not spin up: check power cables and cabling. May also result
from a bad power supply or SATA device.
The SATA connector on the CP3004-SA provides only a data connection. The power for this
device must be supplied by a separate connector. For further information, refer to the re-
spective documentation of the device.
»
SATA device fail message at boot-up: may be a bad cable or lack of power going to the drive.
11.4.4 2.5” HDD / SSD Installation
Up to two 2.5” SATA HDDs/SSDs may be connected to the CP3004-SA. One HDD/SSD may be connected
to the 8 HP CP3004-SA board version equipped with an CP3004-HDD extension module via the SATA
connector J6 located on the extension module. An additional HDD/SSD may be connected to the 12 HP
CP3004-SA board version equipped with an CP3004-HDD extension module and a SATA adapter module.
The second HDD/SSD is connected to the SATA connector J2 located on the SATA adapter module.
Please refer to Figures 28 and 29 for the placement of the 2.5” HDDs/SSDs.
