Functional Description
CP3003-SA
Page 2 - 14
ID 1052-6929, Rev. 3.0
D R A F T — F O R I N T E R N A L U S E O N L Y
SPEED (green/orange/off):
This LED lights up to indicate a successful 100Base-TX or
1000BASE-T connection. When green it indicates a 100Base-TX connection and when orange
it indicates a 1000Base-T connection. When not lit and the ACT-LED is active, the connection
is operating at 10Base-T.
2.11.7
SATA Interfaces
The CP3003-SA provides six SATA interfaces, one SATA 3 Gb/s interface for the SATA Flash
module, one SATA 6 Gb/s interface for the onboard SATA connector J3, one SATA 3 Gb/s in-
terface for the CFast memory card on the CP3003-HDD/CP3003-XMC extension module (8
HP), one SATA 6 Gb/s interface for the SATA 2.5" HDD/SSD on the CP3003-HDD extension
module (8 HP), and two SATA 3 Gb/s interfaces for rear I/O.
All six SATA interfaces provide high-performance RAID 0/1/5/10 functionality.
For further information on the SATA Flash module, refer to Appendix D. For further information
on the SATA interface on the CP3003-HDD extension module, refer to Appendix A.
2.11.7.1
SATA Connector J3
The CP3003-SA is equipped with one standard SATA connector, J3, which is used to connect
a standard HDD/SSD or another SATA device to the CP3003-SA.
Note ...
If the onboard SATA connector will be used, due to the big SATA connector and
the stiff SATA cable, the CP3003-SA may exceed the thickness of 4 HP.
Note ...
To ensure secure connectivity, the SATA connector supports the use of SATA
3 Gb/s cables (SATA cables with locking latch).
Figure 2-4: SATA Con. J3
7
1
Table 2-11: SATA Connector J3 Pinout
PIN
SIGNAL
FUNCTION
I/O
1
GND
Ground signal
--
2
Differential Tr
O
3
SATA_TX-
Differential Transmit -
O
4
GND
Ground signal
--
5
SATA_RX-
Differential Receive -
I
6
Differential R
I
7
GND
Ground signal
--
