CP-RIO6-001/-DD-216/-HD/-HD-216
Functional Description
ID 1043-5620, Rev. 2.0
Page 2 - 7
2.1.4
Serial ATA Interfaces
The CP-RIO6-001 and CP-RIO6-001-DD-216 provide one Serial ATA (SATA) interface for con-
necting a SATA device to the module via a SATA cable. The CP-RIO6-001-HD and the CP-
RIO6-001-HD-216 provide two SATA interfaces, one for connecting a standard 2.5" SATA
HDD/SSD and one for connecting a SATA device via a SATA cable.
The SATA interfaces are capable of supporting SATA 1.5Gb/s and SATA 3Gb/s signaling.
2.1.4.1
SATA Connector J17
The CP-RIO6-001/-DD-216/-HD/-HD-216 rear I/O module is equipped with a SATA connector,
J17, used to connect a standard SATA device to the rear I/O module via a SATA cable. The
rear I/O module will not exceed the thickness of 4HP when a Serial ATA cable is used.
The following figure and table provide pinout information for the SATA connector J17.
Note ...
To ensure secure connectivity, the SATA connector supports the use of SATA
3Gb/s
cables (SATA cables with locking latch).
Figure 2-5: SATA Con. J17
7
1
Table 2-5: SATA Connector J17 Pinout
PIN
SIGNAL
DESCRIPTION
I/O
1
GND
Ground signal
--
2
Differential Tr
O
3
SATA_TX-
Differential Transmit -
O
4
GND
Ground signal
--
5
SATA_RX-
Differential Receive -
I
6
Differential R
I
7
GND
Ground signal
--
