Kontron AM4100, User Manual

Page: 60 / 150

Installation AM4100
Page 3 - 4 ID 36126, Rev. 2.0
P R E L I M I N A R Y
3.2 AM4100 Initial Installation Procedures
The following procedures are applicable only for the initial installation of the AM4100 in a sys-
tem.
To perform an initial installation of the AM4100 in a system, proceed as follows:
1. Ensure that the safety requirements indicated section 3.1 are observed.
2. Before installation, ensure that the board is properly configured for operation in accor-
dance with the application requirements. For information regarding the configuration of
the AM4100, refer to Chapter 4.
3. To install the AM4100, perform the following:
1. Ensure that the board extractor/locking handle is fully extended away from the board.
2. Carefully insert the board into the slot designated by the application requirements for
the board until it makes contact with the AMC carrier/backplane connector. Using min-
imal force, apply pressure to the front panel until the board is seated in the AMC
carrier/backplane connector.
3. Using minimal force, push the extractor/locking handle towards the board until fully re-
tracted.
4. Connect all external interfacing cables to the board as required.
4. The AM4100 is now ready for operation. For operation of the AM4100, refer to the appro-
priate AM4100-specific software, application, and system documentation.
3.3 Standard Removal Procedures
To remove the board proceed as follows:
1. Ensure that the safety requirements indicated in Chapter 3.1 are observed. Particular at-
tention must be paid to the warning regarding the heat sink.
2. Ensure that no power is applied to the system before proceeding.
Warning!
Failure to comply with the instruction below may cause damage to the
board or result in improper system operation.
Warning!
Care must be taken when applying the procedures below to ensure that
neither the AM4100 nor other system boards are physically damaged by
the application of these procedures.
Warning!
Care must be taken when applying the procedures below to ensure that
neither the AM4100 nor other system boards are physically damaged
when applying these procedures.