Kongsberg AIS 200 Installation Manual, rev. 2
Appendix B - Digital interface IEC 61162-1
This field is used to request a message that has been further sub-divided into
alternative data structures. When requesting messages with alternative data
structures, this message subsection identifier must be provided, so that the correct
sub-division of the message data is provided. If the message structure is not sub-
divided into different structures, this field should be null.
This identifies the second distant AIS being interrogated. Only one message may
be requested from the second AIS. The MMSI of the second AIS may be the s
MMSI as the first AIS. This technique can be used to request a third message
from station-1.
NOTE 3
NOTE 4
ame
This senten
ge
8) or Safety Related Broadcast Message (message 14). It provides an external application
ith a means to broadcast data, as defined by the application only – not the AIS. This
f
digital broadcast device. After receiving this sentence, the AIS initiates a VHF broadcast of
either mess
The success
binary Broa
support the generation of an ABK-sentence. The AIS is limited in the amount of encapsulated
ata that can be sent in each slot and frame. If the length of the message would exceed five
e
current fram
10.3.5
BBM – Broadcast binary message
ce supports generation of an ITU-R M.1371 Binary Broadcast Message (messa
w
message o fers great flexibility for implementing system functions that use the AIS like a
age 8 or 14 within 4 s. (Also, see the ABK-sentence.)
or failure of the broadcast confirmed through the use of the "Addressed and
dcast Acknowledgement (ABK)" sentence formatter, and the processes that
d
slots, or the AIS broadcast would exceed the limit of 20 RATDMA slot transmissions for th
e, the AIS will return an ABK-sentence
he contents of the
binary message to the AIS. The first field specifies the total number of sentences
used for a message, minimum value 1. The second field identifies the order of this
sentence in the message, minimum value 1. All sentences contain the same
number of fields. Successive sentences may use null fields for fields that do not
change – such as fields 4 and 5.
NOTE 1 The total number of IEC 61162-1 sentences needed to transfer t
69
Summary of Contents for AIS 200
