Konsberg AIS 200, Installation Manual

Page: 33 / 119

Kongsberg AIS 200 Installation Manual, rev. 2 Installation
Gasket
1. Remove the 4 front panel corners from the MKD.
2. Drill 4 mounting holes and make a panel cut-out according
to dimensional drawing, page 14.
3. Use the supplied gasket between the panel and the unit.
4. Fasten the MKD to the panel with the supplied 19 mm
screws.
5. Apply the front panel corners.
Note!
Do not over-tighten the mounting screws.
3.7.1.2 Bracket mounting (option)
When the MKD is bracket mounted (item A100-85), it is not weatherproof from the back due
to a breathing hole in the back cabinet. When bracket-mounted, the exposed parts of the plugs
should be protected against salt corrosion.
1. Locate the cradle on the mounting site
and mark the 4 holes for the screws on
the mounting surface.
2. Drill the 4 holes and screw the cradle to
the mounting surface.
3. Use the supplied screws to fasten the
MKD to the left and right brackets.
4. Apply the front panel corners.
5. Use the two locking knobs to assemble
the cradle with the left and right
brackets and adjust the MKD for the
best viewing angle.
3.7.2 The optional MKD cable
The optional MKD is connected to the AIS 200 Mobile Unit with a 7-metre cable included
with the MKD.
The connector may be connected to any of the two inputs on the rear side of the MKD.
The table below gives the pin layout for the MKD connector and the 9-pin D-sub connector
that is connected to the Mobile Unit.
23