Konsberg AIS 200, Installation Manual

Page: 29 / 119

Kongsberg AIS 200 Installation Manual, rev. 2 Installation
3.4 Cabling
Double shielded coaxial cables equal or better than RG-214 are recommended when
connecting the GPS and VHF antennas to the AIS 200 system.
Coaxial cables should be installed in separate signal cable channels/tubes and at least 10 cm
away from power supply cables.
All outdoor installed connectors on the coaxial cables should be fitted with preventive
isolation such as shrink-stocking with silicone to protect against water penetration.
Avoid sharp bends of the cables. A bend may change the characteristic impedance of the
cable.
CABLE
NO.
DESCRIPTION CABLE LENGTH PART NO.
1 Interface cable to MKD/Pilot Plug 7 m A101-13-7m
2 Adapter cable GPS 0.5 m A100-93
3
Interconnection cable GPS4 0.5 m A101-03
4 Mounting kit, GPS antenna A101-02
The figure below shows cables and cable length in a standard AIS 200 system.
1
2
4
3
Note!
Shaded items and cables are not part of a standard AIS 200 scope of supply.
19