27
7.13 FAV
1. Press
FAV
key to pop up the favorite group window.
2. Press
keys to select the favorite group.
Press
PR+
,
PR-
keys to select the channel up or
down. Press
OK
key at the selected channel to view it
in full-screen mode. Press
MENU
or
EXIT
key to exit.
3. If there is no favorite channel, system will inform “No
FAV Channel!” when pressing the
FAV
key.
7.14 Teletext
Press
TXT
key to open the Teletext on the screen. If there is no Teletext, the system will inform
“No Teletext Data”. Press
EXIT
key to exit.
7.15 Zoom
1. Press
ZOOM
key to switch between Zoom*1, Zoom*2, Zoom*3, Zoom*4, Zoom*5, Zoom*6,
Zoom*8, Zoom*12, Zoom*16.
2. In zoom mode, press
PR+
,
PR-
keys to move the cursor up, left, right, down.
3. Press
MENU
or
EXIT
key to exit
TROUBLESHOOTING
Problem
Possible causes
What to do
The display on the front
panel does not light up.
Main cable is not connected.
Check that the main cable is plugged into
the power socket.
No sound or picture, but
the front panel shows red
light.
The receiver is in standby
mode.
Press the standby button.
No sound or picture.
The satellite dish is not pointing
at the satellite.
Adjust the dish. Check the signal level in
the Antenna Setup menu.
No signal or weak signal.
Check the cable connections, LNB and
other equipment connected between the
LNB and the receiver, or adjust the dish.
The satellite dish is not pointing
at the satellite.
Adjust the dish.
Signal is too strong.
Connect a signal attenuator to the LNB
input.
Bad picture / blocking
error.
Satellite dish is too small.
Change to a larger dish.
LNB noise factor too high.
Change to an LNB with lower noise factor.
The LNB is faulty.
Change the LNB.
The picture is not shown
on the screen, when
switching on.
The system is connected by
RF leads.
Check the UHF channel fixed in your
system and tune the UHF channel
properly.
There is interference
on your digital satellite
channels, an existing
terrestrial channel or
video signal.
The system is connected by RF
leads and the output channel
of the receiver interferes with
an existing terrestrial channel
or Video signal.
Change the receiver output channel to
a more suitable channel, or connect the
system by SCART leads.
The remote control is not
working.
Battery exhausted.
Change the batteries.