Chapter 6 Daily Care
123
Use a cloth moistened with Cleaner F1 or a Cleaning Wipe to
clean the ADF and other locations.
1
Turn off the scanner and wait for at least 15 minutes.
For information on how to turn the power off, refer to
2
Open the hopper/ADF/top cover.
For information on how to open the hopper, refer to
For information on how to open the ADF, refer to
.
For information on how to open the top cover, refer to
Closing the Top Cover" (page 22)
3
Use a cloth moistened with Cleaner F1 or a Cleaning
Wipe to clean the following locations.
Pick Roller (2 units)
Gently wipe the rollers so that the roller surface does not get damaged.
Wipe along the grooves of the roller surface. Clean thoroughly because
the feeding performance is affected especially when there is foreign
matter stuck on the roller. Remove the rollers for easier cleaning.
For information on how to remove the pick roller, refer to
.
Separator Roller (1 unit)
Gently wipe the rollers so that the roller surface does not get damaged.
Wipe along the grooves of the roller surface. Clean thoroughly because
the feeding performance is affected especially when there is foreign
matter stuck on the roller. Remove the roller for easier cleaning. For
information on how to remove the separator roller, refer to
Replacing the Separator Roller" (page 134)
.
6.3 Cleaning the ADF (with cloth)
The glasses inside the ADF become very hot
when the scanner is being used.
When cleaning the inside of the scanner, make
sure to unplug the power cable and wait for at
least 15 minutes before you start cleaning.
If the hopper has been raised, bring it back down to the lower
position.
For information on how to adjust the hopper level, refer to
Setting the Loading Capacity of the Hopper" (page 23)
.
Be careful not to have your fingers caught
when the ADF closes.
