Konica Minolta CS-7, Operation Manual

Page: 77 / 424

77
Chapter 4
4 .1 Startup and shutdown
• The shutdown screen will be displayed, and
shutdown processing of this device will be car-
ried out . After a short time, the power will be
automatically turned off.
4
Turn off the power for X-ray devices, etc.
connected to this device .
IMPORTANT •••••••••••••••••••••••••••••••••••••
• When turning the power of this device off, always fol -
low the above procedure . Do not turn off the power
with the power switch . Doing so may result in data
loss or damage to the system software .
• When sharing a REGIUS among several units of this
device, shut down all units connected to the JM before
turning off the power of the unit with the JM installed.
• When shutdown coordination is set on this device and
the DR Detector, the DR Detector is not turned off
automatically if the AeroDR Interface Unit, AeroDR In-
terface Unit2, AeroDR Portable RF Unit, AeroDR Por-
table RF Unit2, AeroDR Portable UF Unit, and small-
size access point are turned off before this device is
turned off.
•••••••••••••••••••••••••••••••••••••••••••••••••••••
HINT •••••••••••••••••••••••••••••••••••••
• In cases where a device like REGIUS is connected to
this device and the power is linked, when the power
for this device is turned off, the power for connected
devices is also turned off, or it shifts to sleep status.
• If this device has been continuously operated for one
week without being turned off, a message prompting
for this device restart is displayed . Restart this device
by following the message .
•••••••••••••••••••••••••••••••••••••••••••••••••••••
4 .1 .2 Shutdown of this device
Perform the following procedure from the initial screen
when shutting down this device .
1
Press [System] .
• The system monitor screen is displayed .
2
Press [Shut down] on the system monitor
screen .
• A confirmation screen is displayed.
3
Press [OK] .
• To cancel the system shutdown, press [Cancel],
and then press [Close] on the system monitor
screen . Shutdown operation will be aborted and
the screen will return to the previous screen .