Konica Minolta CS-7, Operation Manual

Page: 76 / 424

76
4 .1 Startup and shutdown
4 .1 .1 Startup of this device
Perform the following procedure when starting up this
device .
1
Turn on the power for X-ray devices, etc .
connected to this device .
2
Press the power switch on this device .
• Startup messages are displayed sequentially .
• Internal system initialization is performed while
the system startup screen is displayed .
• Upon completion of initialization, the initial
screen (patient registration screen or list screen)
is displayed, and this device is ready for opera-
tion .
Patient registration screen
List screen
IMPORTANT •••••••••••••••••••••••••••••••••••••
• When sharing a REGIUS among several units of this
device, start the unit with the JM installed first; after
confirming startup of this unit, start the other units.
•••••••••••••••••••••••••••••••••••••••••••••••••••••
HINT •••••••••••••••••••••••••••••••••••••
• The software version is displayed on the system
startup screen . Initialization will be completed a few
minutes after turning on the power .
• A progress bar is displayed on the system startup
screen, indicating the status of the system initialization
process .
• During startup processing, if startup could not be
completed for any reason, an error message will be
displayed, and the system will transition to shutdown
processing .
• The patient registration screen will be displayed by de-
fault . For the second startup and thereafter, the screen
displayed at the last shutdown will be displayed .
• In cases where a device like REGIUS is connected to
this device and the power is linked, when the power for
this device is turned on, the power for connected de-
vices is also turned on .
• The position of the power switch varies according to the
personal computer you are using . Refer to the product
operation manual for details .
•••••••••••••••••••••••••••••••••••••••••••••••••••••