Konica Minolta CS-7, Operation Manual

Page: 247 / 424

247
7.5 Manual stitching exposure
Chapter 7
7 .5 .3 Image combination
Combine the exposed images. The following proce -
dure describes an example of combining 3 images.
IMPORTANT
•••••••••••••••••••••••••••••••••••••
• Adjust the combination position by using the markers
as supplementary standards in addition to body parts
of the subject .
It is also recommended that you arrange the measure
in the combined image part during exposure to sim -
plify the confirmation of the combined parts.
• In stitching exposure, when plates overlap and are ar -
ranged so that there is no image loss in each plate's
boundaries, there might be a slight gap in the marker
position because of a minute difference in magnifica -
tion. After taking this into account, confirm the combi -
nation position through the marker .
•••••••••••••••••••••••••••••••••••••••••••••••••••••
1
Select the images to be combined .
• Select the images to be combined from the or-
der list and press [ ] or [ ].
• The selected images are displayed in the com-
bined image display area .
• If you pressed [ ], continuously select the
associated images (second and third) .
HINT •••••••••••••••••••••••••••••••••••••
• [ ] and [ ] can be pressed only when the
Exam. Tag for stitching exposure is selected.
•••••••••••••••••••••••••••••••••••••••••••••••••••••
HINT •••••••••••••••••••••••••••••••••••••
• It is also possible to register multiple exposure body
parts in 1 Exam. Tag.
•••••••••••••••••••••••••••••••••••••••••••••••••••••
2
Press [Perform] .
• The exposure screen is displayed.
3
Perform exposure .
• Configure the X-ray device settings and check
the exposure setting before making an expo -
sure .
Press the exposure switch
• Exposed image is displayed.
• Perform the subsequent exposures with same
procedure .