Konica Minolta CM-M6, Instruction Manual

Page: 66 / 128

63
„
Change Target Reference
This section describes how to change the target data selection.
Display the sample for which the target reference is to be changed on the <Sample> screen in advance.
Setting Procedure Start the procedure from the <Sample menu> - <Data management> screen.
1
Use [

] or [

] to move the cursor to “Change
Target reference”, and then press the [Confirmation]
key.
The <Change Target reference> screen is displayed.
2
The target color data number being used will be
displayed. Use [

] or [

] to move the cursor to the
color difference reference color number, and then
press the [Confirmation] key. When the target color
data is set, the screen returns to the <Sample>
screen.
• If
[ESC]
is pressed, the target changes will not be applied
and the screen will return to the
<Data management>
screen .
Notes
If a number to which no color difference target data has
been set, the target will be determined as “None” and
the color difference and pass/fail judgment will not be
displayed.
Data management
Sample
Sample menu [0013]
0002 TARGET-2
Delete data
Change list position
Change Target reference
0002 TARGET-2
Set Sample as Target
Data management
Sample
Sample menu [0013]
0002 TARGET-2
Delete data
Change list position
Change Target reference
0002 TARGET-2
Set Sample as Target
Change Target reference
0004: TARGET-4
2016/8/25 11:18:04
/ 0 0 4 2 0 0