Konica Minolta CM-2600d, Instruction Manual

Page: 37 / 127

E-35
Setting a Measurement Condition
Setting the Measurement Area and Specular Component Mode
2
Turn
B
to select the desired setting, then press
A
.
<Settings>
• M/I+E: Measurement area:ø8 mm, simultaneous measurement of SCI (Specular Component Includ-
ed) and SCE (Specular Component Excluded)
• M/SCI: Measurement area:ø8 mm, SCI (Specular Component Included)
• M/SCE: Measurement area:ø8 mm, SCE (Specular Component Excluded)
• S/I+E: Measurement area:ø3 mm, simultaneous measurement of SCI (Specular Component Includ-
ed) and SCE (Specular Component Excluded)
• S/SCI: Measurement area:ø3 mm, SCI (Specular Component Included)
• S/SCE: Measurement area:ø3 mm, SCE (Specular Component Excluded)
• The measurement area that suits the Target Mask used for measurement or the setting of the lens po-
sition selector switch must be selected.
• With the CM-2500d, only “M/
***
” can be selected.
If the mask type has been changed
from “M/
***
” to “S/
***
” or vice
versa, a message will appear when
A
is pressed, inform you that
the mask (measurement area) has
been changed. The next item will
then appear automatically.