Konica Minolta CM-23d, Instruction Manual

Page: 97 / 151

94 93
Set
ting
3
„ Display type
Configure the display type for the measurement results.
Memo
All display types are selected when the instrument is shipped from the factory.
Operating Procedure Start the procedure from the <Measurement cond.> - <Display cond.> screen.
1
Use [
▲
] or [
▼
] to move the cursor to “Display type”,
and then press the [Confirmation] key.
The <Display type> screen is displayed.
2
Use [
▲
] or [
▼
] to move the cursor to the desired
display type, and then press the [Confirmation] key.
Selections
Absolute value: Displays the absolute values of the
colorimetric values.
Difference: Displays the color difference against the target.
The measurement that failed the pass/fail judgment based
on the tolerance will be highlighted in red.
Abs. & Diff.: Displays the absolute value and the color
difference against the target. The measurement that
failed the pass/fail judgment based on the tolerance will
be highlighted in red.
Pass/Fail: Determines whether the color difference
related to the target are within the tolerance range set in
advance. If within the tolerance, the judgment will be
displayed as “Pass”. If even one difference is not within
the tolerance, the judgment will be displayed as “Fail”.
Custom: Displays the display color value and index set under “Custom” as the two illuminants.
Abs. Graph: Displays a graph of the absolute values of the colorimetric values.
Diff. Graph: Displays a graph showing the color difference value difference against the target.
Spectral Graph: Displays a graph showing the spectral reflectance. The [Confirmation] key can be used to
move the wavelength displaying the spectral reflectance value.
Memo
A check mark means the item is selected.
3
After all settings have been configured, use [
▲
] or [
▼
] to move the cursor to “OK”, and then press
the [Confirmation] key.
The selection is confirmed and the screen returns to the previous screen.
Notes
If [ESC] is pressed without pressing the [Confirmation] key, the settings will not be changed, and the screen
will return to the <Display cond.> screen.