Konica Minolta CA-410 Series, Instruction Manual

Page: 127 / 140

125
Ethernet Connection
1. Connection to a PC via Ethernet
An Ethernet cable can be connected/disconnected even if the power to the instrument is ON. In the following procedure,
however, the power is turned OFF before a cable is connected.
Use an Ethernet cable to connect the instrument to a PC.
Notes
• Connect the connector plug firmly in the correct direction.
• When connecting/disconnecting the cable, be sure to hold the connector plug. Do not hold the cable and pull or bend it
with unreasonable force. Doing so may break the cable.
• Make sure that the cable has sufficient length. Putting tension on the cable may cause connection failure or wire
breakage.
• Pay attention to the shape of the port (connecting terminal) for the cable connector, and push the connector completely
into the port.
Operating Procedure
1
Set the POWER switch to OFF (

).
2
Connect an Ethernet cable to the
Ethernet connector of the instrument.
Ethernet connector
Ethernet cable
3
Check that the plugs are inserted all the
way and connected firmly.
4
Turn the instrument power ON.
• As an Ethernet cable, use a 100Base-TX or a 10Base-T cable.
• If the PC has several Ethernet ports, any port can be used. Note, however, that the instrument may not operate properly
when it is used simultaneously with another device.
CA
-DP40
Communication