Konica Minolta bizhub C35, Service Manual

Page: 211 / 330

DRAFT
10. SER V ICE MODE Field Service V er. 1.0 Feb. 2010
172
ADJUSTMENT
/
SETTING
10.16 CE Password
A. Use
• To set and change the CE password.
B. Procedure
1. Call the Service Mode to the display.
2. Touch [CE Password].
3. Touch [Password] of the upper section, and enter the 8-digit new CE password using
the screen key board or the 10-key pad.
4. Touch [Password] of the lower section, and reenter the 8-digit new CE password using
the screen key board or the 10-key pad.
NOTE
• If Password Rules of Security Settings available from Admin Settings is set to
“ON,” the machine does not accept any new password that contains only the same
character, consists of less than 8 digits, or that is the same as the previous pass-
word.
• In the CE password change display, enter the same CE password to the entry
areas (upper and lower).
• For the CE Password, set a value other than the default.
• Quitting the Service Mode after the new password has been set will validate the
setting of the new password.
• NEVER forget the CE password. When forgetting the CE password, call responsi-
ble person of KMBT.
10.17 Soft Switch
A. Use
• To set the operating characteristic of each function from software switch depending on
what types of printing are normally made.
• To use when the MFP board is replaced.
See P.58
10.18 Engine DipSW
• Not used.