Konica Minolta bizhub C200, User Manual

Page: 162 / 268

C200 6-12
Copy paper/originals
6
5
Touch the button to be programmed, and then touch [Size Registration].
The Registration Size screen appears.
6
Specify the X and Y sides of the paper.
– Make sure that [X] is selected, and then use the keypad to type in the length of side X (between 139.7
mm and 457.2 mm).
– Touch [Y] to select it, and then use the keypad to type in the length of side Y (between 90.0 mm and
311.1 mm).
– Check the illustration in the screen for the sides that are considered X and Y.
– If the value was incorrectly entered, press the [C] (clear) key in the keypad to erase the value, and
then specify the correct value.
7
Touch [OK], and then touch [OK] in the next two screens that appear.
6.2.5 Selecting a setting for oversized paper (Wide Paper settings)
By specifying paper one size larger than the document as wide paper, the document can be copied at the
center so that there is no loss of the document image.
Wide paper can be specified for tray 1 or the bypass tray.
!
Detail
When specifying wide paper for the bypass tray, non-standard-sized paper can be specified. When
using non-standard-sized paper, enter the paper size.
The following procedure describes how to specify the setting for wide paper loaded into the tray 1.
1
In the Basic screen, touch [Paper].
The Paper screen appears.