Konica Minolta bizhub 40p, Service Manual

Page: 171 / 431

11. SER V ICE MENU Field Service V er. 1.0 Dec. 2007
136
bizhub 40P
Adjustment / Setting
B. LEFT ADJUSTMENT
C. DENSITY ADJ
D. LD POWER
E. VIDEO TIME LAG
Function • Adjusts the left margin of media for single-sided printing.
Use
• To correct a misaligned print image.
LEFT ADJ TRAY 1 : Adjust the left margin of media fed from tray 1 (manual tray.)
LEFT ADJ TRAY 2 : Adjust the left margin of media fed from tray 2.
LEFT ADJ TRAY 3 : Adjust the left margin of media fed from tray 3.
LEFT ADJ TRAY 4 : Adjust the left margin of media fed from tray 4.
LEFT ADJ DUPLEX : Adjust the left margin of duplex print media.
Setting
/procedure 1. Select [LEFT ADJUSTMENT] and press the Menu/Select key.
2. Select desired item and press the Menu/Select key.
3. Select desired adjustment amount with the up key
U
/down key
V
and press the
Menu/Select key.
-8 (-4.1 mm) to +7 (+3.6 mm) (1 step: 0.5 mm)
Functions • To adjust image density to target reproduction levels.
Use • An image quality problem is not corrected even after gradation adjust has been run.
Setting/
Procedure
0 to 15
Function • Adjust the intensity of laser output.
Use • The greater the value, the higher the laser output intensity.
Setting
/procedure
0 to 7
Function • Adjust the video output start point.
Use • To fine-adjust the print start position of even-numbered lines in the horizontal direc-
tion in increments of one dot.
• The greater the value, the more the position is on the right side (up to 15 dots right-
ward).
Setting
/procedure
0 to 15