Konica Minolta bizhub 40p, Service Manual, Page: 152 / 431

Field Service V er. 1.0 Dec. 2007 9. Menu
117
bizhub 40P
Adjustment / Setting
C. UNIT OF MEASURE
9.8.4 STARTUP OPTIONS
A. DO STARTUP PAGE
9.8.5 AUTO CONTINUE
9.8.6 HOLD JOB TIMEOUT
Function • Sets the measurement units for custom size mode.
• Sets the measurement units for SYS DEFAULT MENU/DEFAULT PAPER/CUSTOM
SIZE mode.
Use • To change media measurement units.
Setting
/procedure <For North America>
• The default setting is INCHES.
<For other destinations>
• The default setting is MILLIMETERS.
INCHES MILLIMETERS
Function • Sets whether a startup page is printed at startup of the printer.
Use
• To specify whether a startup page is printed.
ON : Start up page is printed at startup the printer.
OFF : Start up page is not printed at startup of the printer.
Setting
/procedure • The default setting is OFF.
ON “OFF”
Function • Select whether or not printing continues if the size or type of media in the selected
tray is different from the size or type of media for the print job.
Use • If AUTO CONTINUE is set to ON, printing automatically continues after about 10 sec-
onds under the following conditions. At this time, printing will be performed even if the
media size is different.
No media: PAPER EMPTY/TRAY EMPTY
Different media size/type: PAPER ERROR/TRAY x PAPER ERR
ON : Auto continuous printing is ON.
OFF : Auto continuous printing is OFF.
Setting
/procedure • The default setting is OFF.
ON “OFF”
Function • Sets the amount of time before a job saved temporarily in the printer is automatically
deleted.
Use • To change the amount of time a job is held before being deleted.
Setting
/procedure • The default setting is DISABLE (No auto delete.).
“DISABLE” 1 hour 4 hours 1 day 1 week
NOTE
• This menu is available only when an optional hard disk kit is installed.