Konica Minolta bizhub 40p, Service Manual

Page: 142 / 431

Field Service V er. 1.0 Dec. 2007 9. Menu
107
bizhub 40P
Adjustment / Setting
(3) SUBNET MASK
(4) DEFAULT GATEWAY
(5) DHCP
(6) BOOTP
Function • Sets the subnet mask of the printer used in the network.
Use • To set the printer’s subnet mask.
Setting
/procedure 1. Select [SUBNET MASK] and press the Menu/Select key.
2. Set desired subnet mask (first bite) with the up key
U
/down key
V
and press the right
key
Z
.
3. Repeat the above procedures and set the subnet mask up to fourth bite.
4. Press the Menu/Select key.
• The default setting is “000.000.000.000.”
000.000.000.000 to 255.255.255.255
Function • Sets the gateway address of the printer used in the network.
Use • To set the printer’s gateway address.
Setting
/procedure 1. Select [DEFAULT GATEWAY] and press the Menu/Select key.
2. Set desired default gateway address (first bite) with the up key
U
/down key
V
and
press the right key
Z
.
3. Repeat the above procedures and set the default gateway address up to fourth bite.
4. Press the Menu/Select key.
• The default setting is “000.000.000.000.”
000.000.000.000 to 255.255.255.255
Function • Automatically acquires an IP address from the DHCP server, if there is one in the
network, and specifies whether to load other network information.
Use
• To automatically acquire an IP address and load other network information.
ON : Enable IP auto acquisition setting.
OFF : Disable IP auto acquisition setting.
Setting
/procedure • The default setting is ON.
“ON” OFF
NOTE
• When setting the IP address manually, the [DHCP] setting is changed to [OFF].
Function • Automatically acquires an IP address from BOOTP and specifies whether to load
other network information.
Use
• To automatically acquire an IP address and load other network information.
ON : Enable IP auto acquisition setting.
OFF : Disable IP auto acquisition setting.
Setting
/procedure • The default setting is OFF.
ON “OFF”
NOTE
• When setting the IP address manually, the [BOOTP] setting is changed to
[OFF].