Konica Minolta bizhub 163, Service Manual

Page: 584 / 588

Field Service Ver. 1.0 Apr. 2007 5. Utility Mode
19
IC-206/NC-503
Adjustment / Setting
(6) AUTO RECEPTION
(7) REPLY ADDRESS
(8) HEADER PRINT
D. USER SETTING
(1) NTP SERVER ADDRESS
(2) TIME ZONE
Functions
• This function is used to specify the time interval (in minutes) for checking E-mail,
when Auto Reception is enabled.
Use
Setting/
Procedure • The default setting is “OFF”.
“OFF” ON
• When [ON] is selected, set the interval time (minute) to check a mail.
The default setting is “15 min”. (1-60min)
NOTE
• FIt will be displayed only when the FK-506 is mounted.
Functions
• This function is used to enter the e-mail address to be used when sending notification
of an error, if an error occurs while receiving an Internet fax.
Use
Setting/
Procedure • Up to 64 characters can be entered for the reply address.
NOTE
• FIt will be displayed only when the FK-506 is mounted.
Functions
• This function is used to specify whether or not to print header information when print-
ing E-mails that have been received.
Use
Setting/
Procedure • The default setting is OFF.
“OFF” ON
NOTE
• FIt will be displayed only when the FK-506 is mounted.
Functions • This function is used to enter NTP server address.
Use • This function is used to set the precise time from the NTP server.
Setting/
Procedure • Input the address of NTP server using the 10-key, and press OK key.
NOTE
• FIt will be displayed only when the FK-506 is unmounted.
Functions • This function is used to set the time gap from the standard time added to the mail
header at mail sending.
Use • This function is used to change the time gap from the standard time.
Setting/
Procedure • Select the corresponding time zone, and press OK key.
NOTE
• FIt will be displayed only when the FK-506 is unmounted.