Konica Minolta bizhub 163, Service Manual

Page: 491 / 588

6. Mechanical adjustment Field Service Ver. 1.0 Apr. 2007
14
PF-502
Adjustment / Setting
6. Mechanical adjustment
6.1 Paper feed unit main scanning registration adjustment
NOTE
• This adjustment is to be made when the PH unit has been replaced.
1. Load the tray2 with A4 crosswise paper.
2. Call the SERVICE MODE to the screen.
3. Select the [FUNCTION] and press the OK key.
4. Select the [PRN TEST PATTERN] and press the OK key.
5. Select the [TRAY2] and press the OK key.
6. Select [PATTERN 1] and press OK key to print out the test pattern.
7. Check width A on the test pattern.
If width A falls outside the specified
range, perform the following steps to
make an adjustment.
Specifications: 20 ± 2.0 mm
8. Slide out the tray2 and loosen the
screw [1].
9. If width A is greater than the speci-
fied range, move the edge guide in
the direction of the arrow.
A
4686F3C500DA
4686F3C501DA
[1]
4686F3C502DA