Konica Minolta AccurioLabel 230, Quick Manual, Page: 168 / 194

6-18 AccurioLabel 230
A media feeding error occurs 6 6.5
6.5 A media feeding error occurs
This section describes typical media errors and remedies for them.
Take an action as shown below according to each problem.
Problem Remedy
Media snakes or is mis-cen-
tered.
The media does not rotate well. 1. Replace the media wound being misaligned.
2. Check the position of the media.
3. Clean adhesive sticking on the parts.
4. Adjust the media conveyance position.
5. Confirm the air pressure of the
manometer .
For details, refer to page 6-19.
Jam code J-1714 or J-3105 is
displayed. 1. Check the position of the media.
2. Clean adhesive sticking on the parts.
3. Clear paper jams.
For details, refer to the following page.
•
For J-1714: page 6-23
• For J-3105: page 6-24
White spots appear on the out-
put paper. 1. Check the position of the media.
2. Clean adhesive sticking on the parts.
3. Adjust the second transfer output.
For details, refer to page 6-24.
The media wrinkles. 1. Adjust the fusing speed.
For details, refer to page 6-25.
The media in the feeding section
goes out alignment. 1. Check the position of the media.
2. Confirm the air pressure of the
manometer .
For details, refer to page 6-25.
A roll end error occurs. Roll Winder RW-110 detected roll end.
Replace the media with a new one.
The status of Roll Winder
RW-110 / Roll Winder RW-210 is
displayed in red.
1. Confirm the preparation before printing.
For details, refer to page 6-25.
"Torque too High, reduce ten-
sion or increase taper" is dis-
played and media is not
transferred. 1. Confirm the preparation before printing.
For details, refer to page 6-25.
The message "Safety door
open" is displayed. Opening of the safety doors of Roll Winder RW-110 and Roll Winder
RW-210 was detected.
Close all of the safety doors.