Konica Minolta 0902, Service Manual

Page: 299 / 302

Chapter 8 Appendix
8-13
8.5 Operation of the Acoustic Wave Tension Meter
Use the acoustic wave tension meter to adjust the belt tension and the wire tension.
This section describes how to operate U-505 for measurement.
([WEIGHT] button will be [MASS] button in case of U-507.)
1
Attach the microphone to the body of the tension
meter.
2
Turn ON by pressing the [POWER] button.
3
Select the [Input No.].
Select in one of following method.
•
Press the [SELECT] button multiple times.(Number
will change in sequence.)
•
Press the number on the numeric keypad.
4
Input the M (unit mass value).
Input the value from numeric keypad after pressing the
[WEIGHT] button.
Press the buttons in following order to input "1.3".
[WEIGHT]
→
[0]
→
[0]
→
[1]
→
[3]
5
Input the W (belt width value).
Input the value from numeric keypad after pressing the
[WIDTH] button.
6
Input the S (span length value).
Input the value from numeric keypad after pressing the
[SPAN] button.
7
Place the microphone close to the center of the
span of the object to measure, but not touching.
8
Press [MEASURE] button.
9
Vibrate the object by tapping it with the finger.
The result is displayed when the vibration sound is
detected and the measurement is performed.
Manufacturer: Gates Unitta Asia
Product name: Sonic Belt Tension Meter
Model: U-505 or U-507
Caution
Before using the acoustic wave tension meter, always read and understand the Operation
Manual for the acoustic wave tension meter.
POWER
WEIGHT WIDTH SPAN
Hz SELECT
MEASURE
0
1
4
7
2
5
8
3
6
9