Konica Minolta 0902, Service Manual

Page: 215 / 302

Chapter 5 Disassembly and Assembly
5-95
4
Remove the connector (JP1) from the first front
side.
5
Remove the grounding cable from the second
front side.
•
1 hex/Phillips-head screw (M5 x 10)
6
Remove the exterior frame (right).
•
A: 3 hex/Phillips-head screws (M4 x 8)
•
B: 14 screws (M4 x 8)
Remove all screws.
7
Remove the noise filter and the circuit protector
unit assembly.
•
Noise filter
•
2 screws (M4 x 8)
•
Grounding cable: 1 screw (M4 x 8)
•
Circuit protector unit assembly
•
2 screws (M4 x 8)
8
Replace the parts.
•
Circuit breaker cover
•
1 screw (M4 x 8)
•
Inlet
•
2 screws (M3 x 6)
Install the circuit protector (power supply circuit
breaker) with the ON side up.
Install the inlet with the ground side facing to the left.
JP1
First Front Side
Second Front
Back Side
Caution
When removing the connector, hold a notch
on the connector without pulling a cable.
Giving a strong pull to the cable may cause
it to be broken.
B
B
B
B
A
B
Second Front Back Side
Black White
Yellow
Blue
Black
White