Konica Minolta 0902, Service Manual

Page: 190 / 302

Chapter 5 Disassembly and Assembly
5-70
11
Loosen the setscrew on the wire presser plate in
the second front back side to remove the wire.
•
1 screw (M4 x 8)
Loosen the screw.
Put down the removed wire without pulling at it or
anything.
12
Loosen the setscrew on the wire presser plate in
the second from side to remove the wire.
•
1 screw (M4 x 8)
Loosen the screw.
13
Disconnect the wire from the encoder.
•
If the encoder is not replaced, skip to Step 21 .
•
If the encoder is replaced, stick the removed wire to
the cassette absorption plate, making sure the wire is
not folded back.
14
Cut off the wiring band binding the encoder cable
(connector: ACN4) and the other cables.
The wired optical unit is shown in the figure for
reference, though the optical unit has been already
removed.
Caution
Handle the wire carefully so as not to
damage or fold it.
Second Front Side
ACN4