Konica Minolta 0902, Service Manual

Page: 170 / 302

Chapter 5 Disassembly and Assembly
5-50
5.4.7 Replacing the Receiver Motor
This section describes the instructions on how to replace the receiver motor.
Work outline
Listed below are the number of people and the rough standard of work hours required for performing the
works described in this section.
Requirements
The works in this section can be performed using only the standard tools.
1
See " Removal Procedures (Page 5-6)" in "5.2.3 Removing/Installing the Exterior Panel and
Insertion Unit" to remove the exterior panel and insertion unit.
2
Remove the exterior frame (front).
•
4 screws (M4 x 8)
Loosen all screws.
3
Remove the connector (JP51).
4
Remove the receiver motor mount board.
•
2 hex/Phillips-head screws (M4 x 8)
Loosen only the upper screw.
Caution
Be sure to turn off the power supply circuit breaker and unplug the power cable from the
equipment whenever you disassemble/assemble the equipment.
Personnel
Number
Work Hours (steps 2 to 11)
1
First Front Side
JP51
First Front Side
Caution
When removing the connector, hold a notch
on the connector without pulling a cable.
Giving a strong pull to the cable may cause
it to be broken.
Loosen