Konica Minolta 0902, Service Manual

Page: 144 / 302

Chapter 5 Disassembly and Assembly
5-24
7
Install the insertion indicator unit assembly.
•
1 tapping screw (M4 x 10)
Move the insertion indicator in the direction of the
arrow shown in the figure to fix it.
8
See " Installation Procedures (Page 5-8)" in "5.2.3 Removing/Installing the Exterior Panel
and Insertion Unit" to install the insertion unit and exterior panel.
Now, you have finished with the procedures to replace the indicator.
5.3.5 Replacing the Barcode Reader
This section describes the instructions on how to replace the barcode reader.
Work outline
Listed below are the number of people and the rough standard of work hours required for performing the
works described in this section.
Requirements
The works in this section can be performed using only the standard tools.
1
See " Removal Procedures (Page 5-6)" in "5.2.3 Removing/Installing the Exterior Panel and
Insertion Unit" to remove the insertion unit.
Reverse the removed insertion unit and place it in a stable place in order to perform the replacing work.
2
Remove the light shield cover.
•
A: 1 tapping screw (M4 x 10)
•
B: 1 screw (M4 x 8)
Remove the sponge protecting the cable at the right
side of the light shield cover too.
Caution
Be sure to turn off the power supply circuit breaker and unplug the power cable from the
equipment whenever you disassemble/assemble the equipment.
Personnel
Number
Work Hours (steps 2 to 7)
1
A
B